Challenger AP10LED User Manual

AP10LED Manager Guide
4
How to OMIT a zone(s)
If you cannot set the alarm system because a detector is faulty and in constant alarm you may need
to omit zones from the alarm system. A zone which has been omitted cannot cause an alarm.
Omitted zones will be restored after the system is unset.
Before a zone can be omitted it has to be enabled by the engineer as “Setup zone attrs/Omit
Allowed” zone.
· Set the system either Full/Part1 or Part2 (for more
information see “How to Setting the System”)
· Press key to go into omit zone window,
and all omit allowed zone is lit.
e.g. To omit zone 4
Press to omit zone 4, the corresponding LED OFF.
Press same key to toggle ON/OFF.
Note: 1-9 key= zone1 –zone 9, 0 key = zone 10.
· Press key to accept and continue setting
or press key to cancel omit function.
·
··
· System work in setting mode
Unsetting the System
When you enter your premises you will need to unset (turn off) the system.
· System is in Set mode.
· Enter User code/Manager code
System returns to Day mode.
CAUTION: Entering an invalid user code will operate the code tamper. After 9 incorrect keys
pushes a full alarm condition will be generated.
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
?
?
?
?
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
R ES TE
4
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
O IMT
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
E
S
T

Challenger AP10LED Specifications

General

Brand	Challenger
Model	AP10LED
Category	Security System
Language	English