Challenger AP10LED User Manual

AP10LED Manager Guide
6
How to go into Manager Program Mode
· System work in Day mode
· Go into Manager Menu.
Press
1 = Setup Codes
There are 2 user codes can be set by LED Keypad in the system. All are 4-digit and can be set to
any number from 0000 to 9999. The access codes ensure that only authorized users can operate the
system.
6=Manager’s Code 1 = user 1, 2 = user 2, 3 = Holiday,
Managers Code Default - 0123
Default User Codes – None Programmed
Managers Code:
The Managers Code (default 0123) can change all codes and has full access to the option in
the user programming mode.
Note: The Managers Code can only be changed from the User Programming Menu.
User 1 – User 2 codes:
The user 1 –user 2 codes have the same operation for testing and Setting and Unsetting,
changing their own code.
Holiday code:
The purpose of this code is to allow access to the property whilst the manager is absent. The
Holiday access code is programmed by the Manager and is only valid until the manager uses
the system. At this point the Holiday code becomes invalid and is no longer accepted by the
control panel.
NOTE: Entering an invalid user code will operate the code tamper. After 9 incorrect
key-push a full alarm condition will be generated.
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10
P OR G
0 1 2 3
Day
PA
TAMP
1
2
3
4
5
6
7
8
9
10

Challenger AP10LED Specifications

General

Brand	Challenger
Model	AP10LED
Category	Security System
Language	English