At Least Twice a Year
Restraint System Check
Make sure the safety belt reminder light and all your
belts, buckles, latch plates, retractors and anchorages
are working properly. Look for any other loose or
damaged safety belt system parts.
If
you see anything
that might keep a safety belt system from doing its
job, have it repaired. Have any torn or frayed safety belts
replaced.
Also look for any opened or broken air bag coverings,
and have them repaired or replaced. (The air bag
system does not need regular maintenance.)
Wiper Blade Check
Inspect wiper blades for wear or cracking. Replace
blade inserts that appear worn or damaged or that
streak or miss areas of the windshield. Also see
Cleaning the Outside
of
Your Vehicle on page 5-84.
Trunk Release Sensor Check
At least twice a year, check to see
if
the system is
working properly. Make sure the horn chirps and the
latch releases. Follow the disabling procedure. See
Trunk on page
2-1
1.
Weatherstrip Lubrication
Silicone grease on weatherstrips will make them last
longer, seal better, and not stick or squeak. Apply
silicone grease with a clean cloth. During very cold,
damp weather more frequent application may be
required. See
Part
D:
Recommended Fluids and
Lubricants on page
6-
15.
Automatic Transaxle Check
Check the transaxle fluid level; add
if
needed. See
Automatic Transaxle Fluid on page 5-23.
A
fluid
loss
may indicate a problem. Check the system and repair
if
needed.
At
Least Once a Year
Key Lock Cylinders Service
Lubricate the key lock cylinders with the lubricant
specified in Part D.
Body Lubrication Service
Lubricate
all
hinges and latches, including those for the
body doors, hood, secondary latch, pivots, spring
anchor, release pawl, rear compartment, glove box door,
console door and any folding seat hardware. Part
D
tells you what to use. More frequent lubrication may be
required when exposed
to
a corrosive environment.
6-1
0
To Next Page
Loading...
Need help?
General
