3. Position the jack (E) and wheel blocks (A) in
the driver’s side trim panel over the
wheelhouse.
4. Turn the wing nut (G) clockwise until the jack
is secured tight in the mounting bracket. Be
sure to position the holes in the base of
the jack onto the pin in the mounting bracket.
5. Use the retaining bracket (C) to fasten the tool
bag (B) on the stud and turn the wing nut (D)
clockwise to secure.
6. Return the storage tray to its original stored
position.
Spare Tire
Your vehicle, when new, had a fully-inflated spare
tire. A spare tire may lose air over time, so check its
inflation pressure regularly. See Inflation - Tire
Pressure on page 509 and Loading Your Vehicle on
page 401 for information regarding proper tire
inflation and loading your vehicle. For instruction on
how to remove, install or store a spare tire, see
Removing the Flat Tire and Installing the Spare Tire
on page 531 and Storing a Flat or Spare Tire and
Tools on page 540.
Your vehicle may have a different size spare tire
than the road tires originally installed on your
vehicle. This spare tire was developed for use on
your vehicle, so it is all right to drive on it. If
your vehicle has four-wheel drive and the different
size spare tire is installed, keep the vehicle in
two-wheel drive.
544
To Next Page
Loading...
Need help?
General
