INSTALLATION STEPS
1. Mount the controller in an area that can be easily viewed by the operator.
2. Install the resolver
3. Install the resolver cable
4. Make all the electrical connections and double check the connections to make sure they are correct
5. Apply power
6. Enable programming by entering the Supervisory Code
7. Zero the resolver at TDC.
8. Program the motion delay and motion detect.
9. Program the batch count as needed
10. Program the Programmable Limit Switch outputs as needed.
11. Program speed compensation (optional)
12. Disable programming to prevent unauthorized changes.
CAUTION: Do not use Programmable Limit Switch outputs for press con-
trol functions unless the press control checks for proper PLS operation
every stroke of the press.
6 6
To Next Page
Loading...
General