Cisco 1000 Series Hardware Installation Guide

CHAPTER 3
Install and Connect the Router
This chapter describes how to install and connect Cisco 1000 Series Integrated Services Router to LAN and
WAN networks.
Read the installation instructions before using, installing or connecting the system to the power source.
Statement 1004
Warning
Installing the Cisco 1000 Series Integrated Services Router involve these tasks:
• Unpack the Router, on page 31
• Set up Router on Desktop, Rack, or Wall, on page 31
• Connect Power Cable, on page 49
• Connect the Router to a Console, on page 51
• Connect WAN and LAN Interfaces, on page 55
• Configure the Router at Startup, on page 56
Unpack the Router
Unpack the router only when you are ready to install it. If the installation site is not ready, to prevent accidental
damage, keep the chassis in its shipping container until you are ready to install.
The router, accessory kit, publications, and any optional equipment you order may be shipped in more than
one container. When you unpack the containers, check the packing list to ensure that you have received all
the listed items.
Set up Router on Desktop, Rack, or Wall
After unpacking, based on your requirements, you can set up a Cisco 1000 Series Integrated Services Router
on a desktop, a rack, or the wall.
Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router
31

Cisco 1000 Series Specifications

General

Brand	Cisco
Model	1000 Series
Category	Network Hardware
Language	English