Cisco 2010 User Manual

4-4
Cisco Connected Grid Routers 2010 Hardware Installation Guide
OL-21559-01
Chapter 4 Configuring the Router
Performing the Initial Configuration on the Router
Cisco IOS Configuration Fundamentals Configuration Guide, Release 12.4, Part 2: Cisco IOS User
Interfaces:Using AutoInstall and Setup:
http://www.cisco.com/en/US/docs/ios/fundamentals/configuration/guide/12_4/cf_12_4_book.html
This section explains how to configure a hostname for the router, set passwords, and configure an
interface for communication with the management network.
Note The following example and the user entries (in bold) are shown as examples only.
Note If you make a mistake while using the setup command facility, you can exit and run the setup command
facility again. Press Ctrl-C, and enter the setup command in privileged EXEC mode (Router#).
Step 1 Enter the setup command facility by using one of the following methods:
• From the Cisco IOS CLI, enter the setup command in privileged EXEC mode:
Router> enable
Password: <password>
Router# setup
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]:
You are now in the Setup Configuration Utility.
The following steps and the user entries (in bold) are shown as examples only.
If you make a mistake while using the setup command facility, you can exit and run the
setup command facility again. Press Ctrl-C, and enter the setup command at the privileged
EXEC mode prompt (Router#). For more information on using the setup command facility, see
The Setup Command chapter in
Cisco IOS Configuration Fundamentals Command Reference ,
Release 12.2T:
http://www.cisco.com/en/US/docs/ios/12_2t/fun/command/reference/122tfr.html
Step 2 To proceed using the setup command facility, enter yes.
Continue with configuration dialog? [yes/no]:
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity.
Would you like to enter basic management setup? [yes/no]: yes
Step 3 Enter a hostname for the router (this example uses myrouter):
Configuring global parameters:
Enter host name [Router]: my router
Step 4 Enter an enable secret password. This password is encrypted (for more security) and cannot be seen
when viewing the configuration.
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.

Cisco 2010 Specifications

General

Brand	Cisco
Model	2010
Category	Network Router
Language	English