Cisco 2010 User Manual

REVIEW DRAFT—CISCO CONFIDENTIAL
5-4
Cisco Connected Grid Routers 2010 Hardware Installation Guide
OL-21559-01
Chapter 5 Installing and Upgrading Internal Modules
Removing and Installing Compact Flash Memory Cards
Removing a Compact Flash Memory Card
To remove a compact flash memory card from the chassis, perform the following steps. See Figure 5-2,
Figure 5-3, and Figure 5-4.
Caution Do not remove a compact flash memory card from the chassis while it is being accessed. The CF LED
blinks to indicate when flash memory is being accessed. Removing the compact flash memory card from
the router while flash memory is being accessed can cause data corruption and erratic operation.
Step 1 Remove the compact flash cover by placing a flat-blade screwdriver in the slot and pushing sideways
against the tension to release the cover door. (See
Figure 5-2 and Figure 5-3.)
Figure 5-2 Inserting Screwdriver Into the Compact Flash Cover
PSU2
PSU OK
PWR-150W-HV
CF1 CF0
DO NOT REMOVE DURING
NETWORK OPERATION
Cisco Connected
DO NOT REMOVE DURING
NETWORK OPERATION
277598
PS
Type
Lo V DC
Hi V DC
or
V AC

Cisco 2010 Specifications

General

Brand	Cisco
Model	2010
Category	Network Router
Language	English