Cisco 2010 User Manual

4-23
Cisco Connected Grid Routers 2010 Hardware Installation Guide
OL-21559-01
Chapter 4 Configuring the Router
Performing the Initial Configuration on the Router
SUMMARY STEPS
1. enable
2. copy nvram:startup-config {ftp: | rcp: | tftp:}
3. show {flash0 | flash1}:
4. copy {flash0 | flash1}: {ftp: | rcp: | tftp:}
DETAILED STEPS
Examples
Copying the Startup Configuration to a TFTP Server: Example
The following example shows the startup configuration being copied to a TFTP server:
Router# copy nvram:startup-config tftp:
Remote host[]? 172.16.101.101
Name of configuration file to write [rtr2-confg]? <cr>
Write file rtr2-confg on host 172.16.101.101?[confirm] <cr>
![OK]
Copying from Flash Memory to a TFTP Server: Example
The following example shows the use of the show {flash0 | flash1}: command in privileged EXEC mode
to determine the name of the system image file, and the use of the copy {flash0|flash1}: tftp: command
in privileged EXEC mode to copy the system image to a TFTP server. The router uses the default
username and password.
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
copy nvram:startup-config {ftp: | rcp: | tftp:}
Example:
Router# copy nvram:startup-config ftp:
Copies the startup configuration file to a server.
• Configuration file copy can serve as a backup copy.
• Enter the destination URL when prompted.
Step 3
show {flash0 | flash1}:
Example:
Router# show {flash0|flash1}:
Displays the layout and contents of a flash memory file
system.
• Learn the name of the system image file.
Step 4
copy {flash0 | flash1}: {ftp: | rcp: | tftp:}
Example:
Router# copy {flash0|flash1}: ftp:
Copies a file from flash memory to a server.
• Copy the system image file to a server to serve as a
backup copy.
• Enter the filename and destination URL when
prompted.

Cisco 2010 Specifications

General

Brand	Cisco
Model	2010
Category	Network Router
Language	English