CHAPTER 2
Installing and Removing Line Cards and
Transceiver Modules
This chapter includes procedures for installing and removing line cards and transceiver modules in the Cisco
ASR 9000 Series Aggregation Services Router.
For hardware installation and configuration information for the Cisco ASR 9000 Series Router, see the
http://www.cisco.com/c/en/us/td/docs/routers/asr9000/hardware/installation/guide/asr9kHIGbk.html
• Safety , on page 69
• Laser Safety, on page 70
• Preventing Electrostatic Discharge, on page 71
• Required Tools and Equipment, on page 72
• Removing and Installing a Line Card, on page 72
• Installing and Removing a Modular Line Card, on page 78
• Installing and Removing Modular Port Adapters, on page 84
• Installing and Removing SFP Modules, on page 96
• Installing and Removing XFP Modules, on page 106
• Installing and Removing 100-Gigabit Ethernet CFP Transceiver Modules, on page 111
• Installing and Removing QSFP+/QSFP28 Transceiver Modules , on page 115
• Installing and Removing CPAK Transceiver or Adapter Modules, on page 120
• Line Card Cable Management, on page 124
• Cables and Connectors, on page 129
Safety
Before you install or remove a line card or transceiver module, review the safety warnings listed in the
http://www.cisco.com/c/en/us/td/docs/routers/asr9000/hardware/rcsi/regulatory/compliance/asr9krcsi.html
To avoid injuring yourself or damaging the equipment.
• Keep the work area clear and dust free during and after installation. Do not allow dirt or debris to enter
into any laser-based components.
• Do not wear loose clothing, jewelry, or other items that could get caught in the router while working
with line cards.
• Cisco equipment operates safely when it is used in accordance with its specifications and product usage
instructions.
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
69
To Next Page
Loading...
Need help?
General
