Cisco ASR 1002 Replacing

Do not remove a USB Flash memory module when issuing some file access command or a read/write operation
to the Flash memory module when it is processing. The router might reload or the USB Flash memory module
can be damaged. You can check to see if the USB activity LED on the Cisco ASR1000-RP front panel is
flashing, prior to the removal of the USB device
Caution
To remove and then replace a USB 1 GB flash token memory stick from a Cisco ASR1000-RP, follow these
steps:
SUMMARY STEPS
1. Pull the memory stick from the USB port.
2. To replace a Cisco USB Flash memory stick, simply insert the module into the USB port 0 or 1 port as
shown in the following figure. The Flash memory module can be inserted only in one way, and can be
inserted or removed regardless of whether the router is powered up or not.
DETAILED STEPS
Step 1 Pull the memory stick from the USB port.
The Cisco ASR 1002 Router has only one USB port.
Note
Step 2 To replace a Cisco USB Flash memory stick, simply insert the module into the USB port 0 or 1 port as shown in the
following figure. The Flash memory module can be inserted only in one way, and can be inserted or removed regardless
of whether the router is powered up or not.
The following figure is only a sample of how the memory stick is inserted into the port and does not display
the Cisco ASR 1000 Series RP faceplate.
Note
Figure 35: Cisco ASR 1000 Series Route Processor 1 Flash Token Memory Stick
You can insert or remove the memory stick whether the router is powered on or not.
Note
What to do next
This completes the USB Flash memory installation procedure.
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
48
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing and Replacing Cisco ASR 1000 Series Router 1 GB USB Flash Token Memory Stick

Cisco ASR 1002 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.3
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
DHCP client	-
Supported network protocols	BGP, GRE, OSPF, DVMRP, EIGRP, IS-IS, IGMPv3, PIM-SM, PIM-SSM
Ethernet LAN (RJ-45) ports	4
Security algorithms	SSH
VPN tunnels quantity	8000
Safety	UL60950-1 CSA, C22.2 No. 60950-1-03, EN 60950-1, IEC 60950-1, AS/NZS 60950.1
Certification	FCC 47CFR15 Class A AS/NZS CISPR 22 CISPR 22 Class A EN55022 Class A ICES-003 Class A VCCI Class A CNS-13438 Class A EN61000-3-2 EN61000-3-3
Internal memory	4096 MB
AC input voltage	85 - 264 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (typical)	560 W
Operating altitude	0 - 3048 m
Storage temperature (T-T)	0 - 50 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Product color	Gray
Rack capacity	2U

Weight and Dimensions

Depth	461 mm
Width	437.4 mm
Height	89 mm
Weight	- g