Cisco ASR 1002 User Manual

Page 37 of 72
5. Configure subject-name settings for the certificate: subject-name
CN=hostname.domain.com,OU=OU-name
Device (ca-trustpoint)#subject-name CN=asrTOE.cisco.com,OU=TAC
6. Set revocation check method: revocation-check crl
Device (ca-trustpoint)#revocation-check crl
Device (ca-trustpoint)#exit
7. Create the certificate signing request: crypto pki enroll trustpoint-name
Device (config)#crypto pki enroll ciscotest
4.6.4.2 Securely Connecting to a Certificate Authority for Certificate
Signing
The TOE must communicate with the CA for Certificate Signing over IPSEC. This
authentication will use pre-shared keys.
Following are sample instructions to configure the TOE to support an IPsec tunnel with aes
encryption, with 10.10.10.102 as the IPsec peer IP on the CA, 10.10.10.110 as the local TOE IP.
TOE-common-criteria#configure terminal
TOE-common-criteria(config)#crypto isakmp policy 1
TOE-common-criteria(config-isakmp)#encryption aes
TOE-common-criteria(config-isakmp)#authentication pre-share
TOE-common-criteria(config-isakmp)#group 14
TOE-common-criteria(config-isakmp)#lifetime 86400
TOE-common-criteria(config)#crypto isakmp key [insert 22 character preshared key]
address 10.10.10.101
TOE-common-criteria(config)#crypto ipsec transform-set sampleset esp-aes esp-sha-
hmac
TOE-common-criteria(cfg-crypto-trans)#mode tunnel
TOE-common-criteria(config)#crypto map sample 19 ipsec-isakmp
TOE-common-criteria(config-crypto-map)#set peer 10.10.10.102
TOE-common-criteria(config-crypto-map)#set transform-set sampleset
TOE-common-criteria(config-crypto-map)#set pfs group14
TOE-common-criteria(config-crypto-map)#match address 170
TOE-common-criteria(config-crypto-map)#exit
TOE-common-criteria(config)#interface g0/0
TOE-common-criteria(config-if)#ip address 10.10.10.110 255.255.255.0
TOE-common-criteria(config-if)#crypto map sample
TOE-common-criteria(config-if)#exit
TOE-common-criteria(config)# access-list 170 permit ip 10.10.10.0 0.255.255.255
10.10.10.0 0.255.255.255

Cisco ASR 1002 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.3
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
DHCP client	-
Supported network protocols	BGP, GRE, OSPF, DVMRP, EIGRP, IS-IS, IGMPv3, PIM-SM, PIM-SSM
Ethernet LAN (RJ-45) ports	4
Security algorithms	SSH
VPN tunnels quantity	8000
Safety	UL60950-1 CSA, C22.2 No. 60950-1-03, EN 60950-1, IEC 60950-1, AS/NZS 60950.1
Certification	FCC 47CFR15 Class A AS/NZS CISPR 22 CISPR 22 Class A EN55022 Class A ICES-003 Class A VCCI Class A CNS-13438 Class A EN61000-3-2 EN61000-3-3
Internal memory	4096 MB
AC input voltage	85 - 264 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (typical)	560 W
Operating altitude	0 - 3048 m
Storage temperature (T-T)	0 - 50 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Product color	Gray
Rack capacity	2U

Weight and Dimensions

Depth	461 mm
Width	437.4 mm
Height	89 mm
Weight	- g