Cisco ASR 1002 User Manual

Page 41 of 72
Or
TOE-common-criteria (config-isakmp)# authentication ecdsa-sig
And for IKEv2 with the commands:
TOE-common-criteria (config)#crypto ikev2 profile sample
TOE-common-criteria(config-ikev2-profile)#authentication [remote | local] rsa-sig
or
TOE-common-criteria(config-ikev2-profile)#authentication [remote | local] ecdsa-sig
If an invalid certificate is loaded, authentication will not succeed.
4.6.4.10 Deleting Certificates
If the need arises, certificates that are saved on the router can be deleted. The router saves its
own certificates and the certificate of the CA.
To delete the router's certificate from the router's configuration, the following commands can be
used in global configuration mode:
Router# show crypto ca certificates [Displays the certificates stored on router]
Router(config)# crypto ca certificate chain name [Enters certificate chain configuration mode]
Router(config-cert-cha)# no certificate certificate-serial-number [deletes the certificate]
To delete the CA's certificate, the entire CA identity must be removed, which also removes all
certificates associated with the CA—router's certificate and the CA certificate. To remove a CA
identity, the following command in global configuration mode can be used:
Router(config)# no crypto ca identity name [Deletes all identity information and certificates
associated with the CA]
4.6.5 Information Flow Policies
The TOE may be configured by the privileged administrators for information flow control/
firewall rules as well as VPN capabilities using the access control functionality. Configuration
of information flow policies is restricted to the privileged administrator.
The VPNGW Extended Package requires that the TOE be able to support options for information
flow policies that include discarding, bypassing, and protecting. On the TOE, an authorized
administrator can define the traffic rules on the box by configuring access lists (with permit,
deny, and/or log actions) and applying these access lists to interfaces using access and crypto
map sets:

Cisco ASR 1002 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.3
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
DHCP client	-
Supported network protocols	BGP, GRE, OSPF, DVMRP, EIGRP, IS-IS, IGMPv3, PIM-SM, PIM-SSM
Ethernet LAN (RJ-45) ports	4
Security algorithms	SSH
VPN tunnels quantity	8000
Safety	UL60950-1 CSA, C22.2 No. 60950-1-03, EN 60950-1, IEC 60950-1, AS/NZS 60950.1
Certification	FCC 47CFR15 Class A AS/NZS CISPR 22 CISPR 22 Class A EN55022 Class A ICES-003 Class A VCCI Class A CNS-13438 Class A EN61000-3-2 EN61000-3-3
Internal memory	4096 MB
AC input voltage	85 - 264 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (typical)	560 W
Operating altitude	0 - 3048 m
Storage temperature (T-T)	0 - 50 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Product color	Gray
Rack capacity	2U

Weight and Dimensions

Depth	461 mm
Width	437.4 mm
Height	89 mm
Weight	- g