Cisco ASR 9001-S Hardware Installation Guide

1-25
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
OL-26701-02
Chapter 1 Preparing for Installation
Cisco ASR 9001 Router Port Connection Guidelines
Management LAN Port LED Indicators
The Management LAN connectors have integral LED indicators (see Figure 1-24). When lit, these LEDs
indicate:
• Green (LINK)—Connection is alive.
• Amber (ACT)—Connection is active.
Figure 1-24 RP Management LAN Port LED Indicators
Management LAN RJ-45 Cabling
When connecting the RJ-45 port to a hub, repeater, or switch, use the straight-through cable pinout
shown in Figure 1-25.
Note To comply with the intra-building lightning surge requirements of Telecordia GR-1089-CORE, Issue II,
Revision 01, February 1999, you must use a shielded cable when connecting the management LAN ports
on the RP card. The shielded cable is terminated by shielded connectors on both ends, with the cable
shield material tied to both connectors.
4— BI_DC+
5— BI_DC–
6 Receive– BI_DB–
7— BI_DD+
8— BI_DD–
Table 1-5 RP Management LAN Port Signals (continued)
MGT LAN Port Pin 10Base-T, 100Base-TX Signal 1000Base-T Signal
332427

Cisco ASR 9001-S Specifications

General

Brand	Cisco
Model	ASR 9001-S
Category	Network Router
Language	English