Cisco ASR 9001-S Hardware Installation Guide

3-13
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
OL-26701-02
Chapter 3 Installing Modules and Cables in the Chassis
Cable Management
Figure 3-7 Cable-Management Tray Installation and Removal
Step 3
Insert and tighten the captive screw(s) to secure the tray. (see Figure 3-7).
Step 4 Connect all the cables to the intended ports and pass them throught the cable management tray in an
organized manner.
Removing a Cable-Management Tray
To remove a cable-management tray, follow these steps (see Figure 3-7):
Step 1 Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 2 Note the current interface cable connections to the ports on the RP.
Step 3 Starting with the interface cable for the bottom port on the RP, disconnect the cable from the RP
interface.
Step 4 Repeat Step 3 for all remaining interface cables, proceeding from the bottom ports upward, then proceed
to Step 5.
Step 5 Loosen the captive installation screw on the cable-management tray and remove the tray from the chassis
(see Figure 3-7).
1 Cable-Management Tray
1
332147

Cisco ASR 9001-S Specifications

General

Brand	Cisco
Model	ASR 9001-S
Category	Network Router
Language	English