Cisco ASR 9006 Unpacking And Installing

If you ordered the optional accessories set, see Installing Optional Chassis Accessories on the Cisco ASR
9010 Router, on page 70 to install both the base and optional accessories.
Note
If you did not order the optional accessory set, follow these steps to install the supplied base chassis accessories
on the Cisco ASR 9006 Router.
Procedure
Step 1 Attach the plastic accessory piece to the fan tray door using two supplied screws. Insert the screws through
the fan tray door from the inside of the door into the accessory piece (see the figure below).
Step 2 Attach the left metal mounting bracket to the front upper left corner of the chassis with three screws.
Figure 74: Installing Plastic Fan Tray Door Accessory and Metal Mounting Brackets on the Cisco ASR 9006 Router
Metal mounting
bracket on right
upper corner of
chassis
3Metal mounting
bracket on left upper
corner of chassis
2Plastic fan tray door
accessory
1
Step 3 Attach the right metal mounting bracket to the front upper right corner of the chassis with three screws.
Step 4 Attach the left and right side brackets to the chassis front edge on each side (see the figure below). Attach
each bracket to the chassis using three screws per bracket inserted from the inside of the chassis, through the
three chassis tabs into the plastic brackets. Tighten the screws to a torque of 7 in-lb (0.80 N-m).
Unpacking and Installing the Chassis
76
Unpacking and Installing the Chassis
Installing Base Chassis Accessories on the Cisco ASR 9006 Router

Cisco ASR 9006 Specifications

General

Brand	Cisco
Model	ASR 9006
Category	Network Router
Language	English