Cisco ASR 920 series Installing Manual

Step 4 Insert the SFP module into the slot until you feel the connector on the module snap into place in the rear of
the slot.
Figure 12: Installing an SFP Module into an SFP Module Slot
Do not remove the dust plugs from the fiber-optic SFP module port or the rubber caps from the
fiber-optic cable until you are ready to connect the cable. The plugs and caps protect the SFP module
ports and cables from contamination and ambient light. Store the dust plugs for later use.
Caution
Step 5 Insert the cable connector into the SFP module:
• For fiber-optic SFP modules, insert the LC cable into the SFP module.
• For copper 1000BASE-T SFP modules, insert the RJ-45 cable connector into the SFP module.
Removing SFP Modules
To remove an SFP module from a module receptacle, follow these steps:
Procedure
Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.
Step 2 Disconnect the cable from the SFP module, and insert a dust plug into the cable end.
For reattachment, note which cable connector plug is send (TX) and which is receive (RX).
Tip
Installing the Cisco ASR 920 Series Router
14
Installing the Cisco ASR 920 Series Router
Removing SFP Modules

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English