Cisco ASR 920 series Installing Manual

Procedure
Step 1 Ensure that the system (earth) ground connection has been made.
Step 2 If necessary, remove the blank power supply filler plate from the chassis power supply bay opening by
loosening the captive installation screws.
Step 3 Grasp the power supply handle with one hand. Place your other hand underneath the power supply. Slide the
power supply into the power supply bay. Make sure that the power supply is fully seated in the bay. See the
following figure.
Figure 56: Installing the AC Power Supply Module
Step 4 Slide the AC power supply cord inside the tie of the tie-and-holder and tighten the tie around the power supply
cord.
Step 5 Plug the power supply cord into the AC power supply.
Installing the Cisco ASR 920 Series Router
61
Installing the Cisco ASR 920 Series Router
Installing the AC Power Supply Module

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English