Pole Mounting the AP with Horizontal Kit
The AIR-MNT-HORZ1= mounting kit contains a mounting L-bracket and components for both pole mounting
and wall mounting. Using this kit, you can install the AP on a pole or mast. It supports metal, wood, or
fiberglass poles from 2 to 5 inches (51 to 127 mm) in diameter.
Figure 65: Pole Mounted Horizontal Kit (AIR-MNT-HORZ1=)
L-Bracket1
Solar Shield2
(4) M6 x 12–mm Hex-head Bolts3
(4) 8-32 x 0.62” Phillips Pan Head Screw4
(2) Adjustable Band Clamps 2 to 5 inch (51 to 127 mm) Dia. passing through the bracket slots5
Before you begin
Ensure that you have the following materials before beginning to mount the AP horizontally to a pole:
Table 10: Materials Needed for Mounting the AP using AIR-MNT-HORZ1= Kit
Supplied in the
Kit?
Materials Required
YesWall/Pole Mount L-Bracket
YesSolar Shield
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
57
Installation Overview
Pole Mounting the AP with Horizontal Kit
To Next Page
Loading...
Need help?
General
