Figure 73: Installing the AP Cover on an Installed AP
Procedure
Step 1 Position and rotate the cover over the AP.
Figure 74: Installing the AP Cover Kit
Step 2 Carefully pull back the flanged wall with screws to pass the cover over the AP. The covers are a snug fit to
the AP.
Step 3 Align the two captive screws on the top of the cover with the screw holes.
Installing a Lightning Arrestor
Overvoltage transients can be created through lightning static discharges, switch processes, direct contact
with power lines, or through earth currents. The Cisco Aironet AIR-ACC245LA-N Lightning Arrestor limits
the amplitude and duration of disturbing interference voltages and improves the over voltage resistance of
in-line equipment, systems, and components. A lightning arrestor installed according to these mounting
instructions balances the voltage potential, thus preventing inductive interference to parallel signal lines within
the protected system.
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
64
Installation Overview
Installing a Lightning Arrestor
To Next Page
Loading...
Need help?
General
