• When mounting an AP vertically, ensure that the AP is oriented with the LED indicators pointing down.
• Mount the AP in such a way that all antenna ports and the console port are visible and accessible for
future use.
• Align the AP’s omnidirectional antennas vertical to the ground.
• Align the AP’s directional antenna such that the main beam is parallel to or tilted down toward the
horizon.
Note
Vertically Mounting the AP to a Wall
The AIR-MNT-VERT1= mounting kit contains a mounting bracket for wall mounting or pole mounting.
You can use the mounting bracket as a template to mark the mounting holes' positions for your installation,
install the mounting bracket, and then attach the AP to the bracket.
The mounting wall, attaching screws, and wall anchors must support a 50-lb (22.7–kg) static weight.
Caution
Figure 53: Mounting Bracket for Wall and Pole Mounting
One of four keyhole slots to mount the AP.1
One of four slots for steel band clamps, used for pole mounting only.2
Bracket mount holes for fastening bracket to the wall. You can use bolts of up to 1/4” or 6 mm in
diameter.
3
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
40
Installation Overview
Vertically Mounting the AP to a Wall
To Next Page
Loading...
Need help?
General
