Cisco Catalyst 3560CX Series User Manual

PurposeCommand or Action
Device(config)# end
Verifies the operation status of network ports and stack
ports.
show switch horizontal-stack-ports
Example:
Step 5
Device# show switch hstack-ports
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Step 6
Device# copy running-config startup-config
Reloads the configuration.reload
Example:
Step 7
Device# reload
What to do next
To convert a stack port into a network port, run the no switch switch-number hstack-port stack-port command:
Device(config)# no switch 1 hstack-port 1 TenGigabitEthernet 1/0/1
Device# copy running-config startup-config
Device# reload
After configuration, restart the switch to convert the stack port into a network port.
Note
Stack port to network port conversion and vice versa cli is not nvgened. On write erase reload, the switch in
stack mode will not be converted to standalone, and manual conversion of stack port to network port is required.
Note
Enabling the Persistent MAC Address Feature
When you enter the command to configure this feature, a warning message appears with the consequences of
your configuration. You should use this feature cautiously. Using the old active switch MAC address elsewhere
in the same domain could result in lost traffic.
Note
Follow these steps to enable persistent MAC address:
Managing Switch Stacks
12
Managing Switch Stacks
Enabling the Persistent MAC Address Feature

Cisco Catalyst 3560CX Series Specifications

General

Brand	Cisco
Model	Catalyst 3560CX Series
Category	Switch
Language	English