Cisco Catalyst 3560CX Series User Manual

4. copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Step 1
Device enable
Specifies the stack member number and the new priority
for the stack member. The stack member number range is
1 to 8. The priority value range is 1 to 15.
switch stack-member-number priority new-priority-number
Example:
Device# switch 3 priority 2
Step 2
You can display the current priority value by using the show
switch user EXEC command.
The new priority value takes effect immediately but does
not affect the current active stack. The new priority value
helps determine which stack member is elected as the new
active stack when the current active stack or switch stack
resets.
Verify the stack member priority value.show switch stack-member-number
Example:
Step 3
Device# show switch
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Step 4
Device# copy running-config startup-config
Provisioning a New Member for a Switch Stack
This optional task is available only from the active switch.
SUMMARY STEPS
1. show switch
2. configure terminal
3. switch stack-member-number provision type
4. end
5. copy running-config startup-config
Managing Switch Stacks
16
Managing Switch Stacks
Provisioning a New Member for a Switch Stack

Cisco Catalyst 3560CX Series Specifications

General

Brand	Cisco
Model	Catalyst 3560CX Series
Category	Switch
Language	English