Cisco Catalyst 9600 Series User Manual

MeaningLED Position or Colour
Indicates one of the following:
• No output power available
• AC/DC input is below the operating range
• No 12V standby from a parallel unit is available
• Over voltage/over current/over temperature conditions
• Over-temperature protection (OTP) due to fan failure
Solid Amber
Indicates warning events such as a power supply module that continues
to operate in high temperature or high power and a fan that runs slow
and so on.
1Hz Blinking Amber
Indicates that power switch is turned off with AC/DC input power
available or that the power supply is in standby mode.
2Hz Blinking Green
Indicates bootloading mode.1Hz Blinking Green
Indicates one of the following:
• No input or output power available
• AC/DC input is below the operating range
• No 12V standby from a parallel unit
Off
Supervisor Module LEDs
Table 12: LEDs and the Status
MeaningLED Position or ColourLED type
Indicates that all diagnostic tests have passed after
image booting.
Green
STATUS
Indicates a major environmental warning.Amber
Indicates a fault in the module due to parity error or
failed diagnostic tests or hardware failure.
Red
Indicates that the supervisor module is disabled or is
not powered up.
Off
Identifies the supervisor module receiving the beacon
signal.
Solid blue
BLUE BEACON
Cisco Catalyst 9600 Series Switches Hardware Installation Guide
98
LEDs
Supervisor Module LEDs

Cisco Catalyst 9600 Series Specifications

General

Brand	Cisco
Model	Catalyst 9600 Series
Category	Switch
Language	English