Cisco CGR 2010 User Manual

31
Installing and Connecting the Router
Power-Supply Modules
Figure 5 Cisco CGR 2010 Router Power Supply Inserted Into the Router
Connecting AC Power
This section explains how to connect AC power to the Cisco CGR 2010 router.
Warning: Read the installation instructions before connecting the system to the power source. Statement 1004
To connect an AC power supply:
1. Verify that power is off to the circuit on the power supply that you are removing. As an added precaution, place the
appropriate safety flag and lockout devices at the source power circuit breaker, or place a piece of adhesive tape
over the circuit breaker handle to prevent accidental power restoration while you are working on the circuit.
2. Observe the power-input terminal on the left edge of the router’s cable side. See Figure 6 on page 32
1 Power supply 2 Power supply captive screws
277597
PSU1 PSU2
PSU OK
PWR-150W-HV
SYS SPD SPD SPD SPD 2 01USB
CON
ACT
SFP
0/0
EN
SFP
0/1
EN
GE
0/1
LINK
GE
0/0
LINK
PSU
23
1 CONSOLE
SLOT
CF1
DO NOT REMOVE DURING
NETWORK OPERATION
CF0
DO NOT REMOVE DURING
NETWORK OPERATION
Cisco 2935R
“CAUTION: This unit may have more than one power source.
Disconnect all power sources before servicing to avoid electric chock.”
PS Type
LoV dc
HiV dc
V ac, 50/60 Hz
10A
2A
2A
Input Rating Per Sources
24-60V
100-270V
100-240V ~
PSU1 PSU2
PSU OK
PWR-150W-HV
SYS SPD SPD SPD SPD 2 01
USB
CON
ACT
SFP
0/1
EN
SFP
0/0
EN
GE
0/1
LINK
GE
0/0
LINK
PSU
23
1
CONSOLE
SLOT
CF1 CF0
PSU OK
PWR-150W-HV
DO NOT REMOVE DURING
NETWORK OPERATION
DO NOT REMOVE DURING
NETWORK OPERATION
Cisco Connected Grid Router 2000 Series
CAUTION: This unit may have more than
one power source. Disconnect all power
sources before servicing to avoid
electric shock.
PSU OK
PWR-150W-HV
2
1
2
PS
Type
Input Terminal
Symbol
Input Rating
Per Source
Lo V DC
Hi V DC
Lo 24 - 60 V
10A
100-250V 2A
100-240V
~
2A
50-60 Hz
Hi
or
V AC
~

Cisco CGR 2010 Specifications

General

Brand	Cisco
Model	CGR 2010
Category	Network Router
Language	English