B-7
Cisco Physical Security Multiservices Platform Series User Guide
OL-21838-03
Appendix B Recovering from a Hard Drive Failure
Reimaging a Multiservices Platform Series Device that is Running Cisco PAM
b. Press F10 to configure.
c. Press Spacebar to choose SPAN-1.
d. Press F10 to continue.
e. Specify RAID = 0.
f. Choose Accept and press Enter.
g. Press Esc to leave configuration mode and Yes to save the configuration.
h. Press Esc again.
Step 15 Press Esc to return to the Management menu.
Step 16 Press Esc to exit and Yes to confirm.
Step 17 Insert the operating system disc for your release of Cisco IPICS and press Ctrl-Alt-Del to reboot
Note If you are using the 1-RU Multiservices Platform Series model, you need to attach a USB DVD
drive.
When the system reboots, the operating system installation process begins. See Cisco IPICS Server
Installation and Upgrade Guide Release for your release of Cisco IPICS for detailed information about
installing the operating system.
Reimaging a Multiservices Platform Series Device that is
Running Cisco PAM
Reimaging a Multiservices Platform Series Device that is running Cisco PAM involves reconfiguring
RAID to make replacement hard drives visible to a server and resetting the server to the factory defaults.
Before reimaging a server, replace the failed hard drive.
To reimage a server, see the “Reinstalling the Cisco PAM Server Software from a Recovery CD” section
in Cisco Physical Access Manager User Guide for your release of Cisco PAM.
To Next Page
Loading...
Need help?
General
