Cisco Firepower 2130 Hardware Installation Guide

CHAPTER 3
Mount and Connect
• Unpack and Inspect the Chassis, on page 45
• Rack-Mount the Chassis, on page 46
• Rack-Mount the Chassis Using Slide Rails, on page 48
• Ground the Chassis, on page 54
• Connect Cables, Turn on Power, and Verify Connectivity for Cisco Firepower Threat Defense, on page
57
• Connect Cables, Turn on Power, and Verify Connectivity Using Cisco Firepower Management Center,
on page 60
• Connect Cables, Turn on Power, and Verify Connectivity for Cisco ASA, on page 62
Unpack and Inspect the Chassis
Keep the shipping container in case the chassis requires shipping in the future.
Tip
The chassis is thoroughly inspected before shipment. If any damage occurred during transportation or any
items are missing, contact your customer service representative immediately.
Note
See Package Contents, on page 4 for a list of what shipped with the chassis.
Step 1 Remove the chassis from its cardboard container and save all packaging material.
Step 2 Compare the shipment to the equipment list provided by your customer service representative. Verify that you have all
items.
Step 3 Check for damage and report any discrepancies or damage to your customer service representative. Have the following
information ready:
• Invoice number of shipper (see the packing slip)
• Model and serial number of the damaged unit
• Description of damage
Cisco Firepower 2100 Series Hardware Installation Guide
45

Cisco Firepower 2130 Specifications

General

Brand	Cisco
Model	Firepower 2130
Category	Firewall
Language	English