Cisco Firepower 2130 Hardware Installation Guide

Figure 40: Inner Rail Release Clip
Inner rail attached to chassis2Inner rail release clip1
Step 7 Use the captive screws on the front of the mounting brackets to fully secure the chassis to the rack.
What to do next
Continue with the following procedures:
• Ground the Chassis, on page 54
• Connect Cables, Turn on Power, and Verify Connectivity for Cisco Firepower Threat Defense, on page
57
• Connect Cables, Turn on Power, and Verify Connectivity Using Cisco Firepower Management Center,
on page 60
• Connect Cables, Turn on Power, and Verify Connectivity for Cisco ASA, on page 62
Ground the Chassis
Take note of the following warnings:
Statement 1024—Ground Conductor
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence
of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician
if you are uncertain that suitable grounding is available.
Warning
Cisco Firepower 2100 Series Hardware Installation Guide
54
Mount and Connect
Ground the Chassis

Cisco Firepower 2130 Specifications

General

Brand	Cisco
Model	Firepower 2130
Category	Firewall
Language	English