EasyManuals Logo
Home>Cisco>Firewall>Firepower 4110

Cisco Firepower 4110 Hardware Installation Guide

Cisco Firepower 4110
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
Statement 1040Product Disposal
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1045Short-Circuit Protection
This product requires short-circuit (overcurrent) protection to be provided as part of the building installation.
Install only in accordance with national and local wiring regulations.
Warning
Statement 1074Comply with Local and National Electrical Codes
To reduce risk of electric shock or fire, installation of the equipment must comply with local and national
electrical codes.
Warning
Network Equipment-Building System (NEBS) Statements
NEBS describes the environment of a typical United States Regional Bell Operating Company (RBOC) central
office. NEBS is the most common set of safety, spatial, and environmental design standards applied to
telecommunications equipment in the United States. It is not a legal or regulatory requirement, but rather an
industry requirement.
The following NEBS statements apply to the Firepower 4120:
Statement 7003Telcordia GR-1089 NEBS Standard for Electromagnetic Compatibility and Safety
The intrabuilding port(s) of the equipment or subassembly must use shielded intrabuilding cabling/wiring that
is grounded at both ends.
Warning
Statement 7005Intrabuilding Lightning Surge and AC Power Fault
The intrabuilding port(s) of the equipment or subassembly must not be metallically connected to interfaces
that connect to the outside plant (OSP) or its wiring. These interfaces are designed for use as intrabuilding
interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE) and require isolation from the exposed
OSP cabling. The addition of primary protectors is not sufficient protection to connect these interfaces
metallically to OSP wiring.
Warning
Statement 7012Equipment Interfacing with AC Power Ports
This equipment shall be connected to AC mains provided with a surge protective device (SPD) at the service
equipment complying with NFPA 70, the National Electrical Code (NEC).
Warning
Cisco Firepower 4110, 4120, 4140, and 4150 Hardware Installation Guide
42
Installation Preparation
Network Equipment-Building System (NEBS) Statements

Other manuals for Cisco Firepower 4110

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Firepower 4110 and is the answer not in the manual?

Cisco Firepower 4110 Specifications

General IconGeneral
BrandCisco
ModelFirepower 4110
CategoryFirewall
LanguageEnglish

Related product manuals