Cisco Intelligent Wireless Access Gateway User Manual

For information about the field-replaceable units (FRUs) of the Cisco ASR 1000 Series Aggregation Services
Routers supported by each ROMmon release, see the "ROMmon Release Requirements" section in the Cisco
ASR 1000 Series Aggregation Services Routers Release Notes.
How to Configure the iWAG
Configuring the iWAG for Simple IP Users
You must configure the Cisco Intelligent Services Gateway (ISG) for the iWAG to enable simple IP users to
access Internet services.
The tasks listed below enable IP sessions and indicate how these sessions are identified. For detailed steps,
see the "Creating ISG Sessions for IP Subscribers" section in the Intelligent Services Gateway Configuration
Guide.
•
Creating ISG IP interface sessions
•
Creating ISG Static Sessions
•
Creating ISG IP Subnet Sessions
•
Configuring IP Session Recovery for DHCP-Initiated IP Sessions
•
Verifying ISG IP Subscriber Sessions
•
Clearing ISG IP Subscriber Sessions
•
Troubleshooting ISG IP Subscriber Sessions
You must configure DHCP support in your network before performing the tasks listed below. For detailed
steps on assigning IP addresses using DHCP, see the "Assigning ISG Subscriber IP Addresses by Using
DHCP" section in the Intelligent Services Gateway Configuration Guide.
•
Configuring an ISG Interface for Dynamic DHCP Class Association
•
Configuring DHCP Server User Authentication
•
Configuring a DHCP Class in a Service Policy Map
•
Configuring a DHCP Class in a Service Profile or User Profile on the AAA Server
•
Configuring a DHCP Server IP Address
Configuring the iWAG for 3G Mobile IP Users
You must configure GTP for the iWAG to allow access to 3G mobile IP users. The various tasks described
in the following sections are mandatory for configuring the iWAG for 3G mobile IP users.
Configuring Authentication, Authorization, and Accounting for the iWAG
This section describes how to configure authentication, authorization, and accounting (AAA) for the iWAG
on the Cisco ASR 1000 Series Aggregation Services Routers.
Intelligent Wireless Access Gateway Configuration Guide
8 OL-30226-03
Overview of the Intelligent Wireless Access Gateway
How to Configure the iWAG

Cisco Intelligent Wireless Access Gateway Specifications

General

Brand	Cisco
Model	Intelligent Wireless Access Gateway
Category	Gateway
Language	English