Cisco Intelligent Wireless Access Gateway User Manual

SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface GigabitEthernet slot/subslot/port
4.
description string
5.
ip address ip-address mask [secondary [vrf vrf-name ]]
6.
negotiation auto
DETAILED STEPS
PurposeCommand or Action
Enables the privileged EXEC mode.enable
Step 1
Example:
Router> enable
Enter your password, if prompted.
Enters the global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Enters the interface configuration mode for Gigabit
Ethernet interface.
interface GigabitEthernet slot/subslot/port
Example:
Router(config)# interface GigabitEthernet 1/3/5
Step 3
Adds a description to an interface configuration.
description string
Example:
Router(config-if)#description interface connected
to GGSN
Step 4
Sets a primary IP address or secondary IP address for
an interface.
ip address ip-address mask [secondary [vrf vrf-name ]]
Example:
Router(config-if)# ip address 192.170.10.1
255.255.0.0
Step 5
Enables auto negotiation on a Gigabit Ethernet
interface.
negotiation auto
Example:
Router(config-if)# negotiation auto
Step 6
Enabling Mobile Client Service Abstraction
This section describes how to enable Mobile Client Service Abstraction (MCSA) for PMIPv6.
Intelligent Wireless Access Gateway Configuration Guide
OL-30226-03 17
Overview of the Intelligent Wireless Access Gateway
Configuring the iWAG for 3G Mobile IP Users

Cisco Intelligent Wireless Access Gateway Specifications

General

Brand	Cisco
Model	Intelligent Wireless Access Gateway
Category	Gateway
Language	English