Cisco NCS 5501 User Manual

What to Do Next
1
Enter the IP address for the management interface.
The software asks for the Mgmt0 IPv4 netmask.
2
Enter a network mask for the management interface.
The software asks if you need to edit the configuration.
3
Enter no to not edit the configuration.
The software asks if you need to save the configuration.
4
Enter yes to save the configuration.
Installing and Removing Transceiver Modules
Installing and Removing SFP Modules
Before you remove or install an SFP or SFP+ module, read the installation information in this section.
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams
or view directly with optical instruments. Statement 1051
Warning
Protect the line card by inserting a clean SFP/SFP+ module cage cover, shown in the figure below, into
the optical module cage when there is no SFP or SFP+ module installed.
Caution
Figure 19: SFP/SFP+ Module Cage Cover
Hardware Installation Guide for Cisco NCS 5500 Series Fixed-Port Routers
39
Connect Router to the Network
Installing and Removing Transceiver Modules

Cisco NCS 5501 Specifications

General

Brand	Cisco
Model	NCS 5501
Category	Network Router
Language	English