When you enable LLDP drop on the client controller ports of the muxponder or muxponder slice, the LLDP
frames drop on the ports without forwarding.
Configuring LLDP Drop
You can configure the LLDP drop for a muxponder or muxponder slice. By default, the LLDP drop status is
set to False. On enabling the LLDP Drop, the status is set to True.
To configure LLDP drop on a muxponder use the following command:
configure
hw-module location location mxponder drop-lldp
Use the no form of the command to disable LLDP drop.
Note
commit
Limitation
• When you disable LLDP globally, the LLDP gets disabled on all the interfaces.
By default, LLDP is enabled for NCS 1004. But when you enable and disable LLDP in the global configuration
mode, LLDP gets disabled on all the interfaces.
Workaround: You must enable LLDP globally or reload the Router.
Note
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios#hw-module location 0/1 mxponder drop-lldp
RP/0/RP0/CPU0:ios#commit
configure
hw-module location location mxponder-slice slice-number drop-lldp
Use the no form of the command to disable LLDP drop.
Note
To configure LLDP drop on a muxponder slice, use the following command:
commit
The following is a sample in which slice 0 client ports are enabled with LLDP drop.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#hw-module location 0/1 mxponder-slice 0 drop-lldp
RP/0/RP0/CPU0:ios(config)#commit
Verifying the Status of LLDP Drop
To verify the LLDP drop enabled status, use the following command.
Configuring Controllers
22
Configuring Controllers
Configuring LLDP Drop
To Next Page
Loading...
Need help?
General
