Cisco NCS1004 User Manual

The following sample shows the output of show controllers hundredGigEctrlr command, before configuring
MAC address or ARP snoop on client ports.
RP/0/RP0/CPU0:ios#show controllers hundredGigECtrlr 0/1/0/2
Mon Mar 16 19:40:37.434 UTC
Operational data for interface HundredGigECtrlr0/1/0/2:
State:
Administrative state: enabled
Operational state: Up
LED state: Green On
Maintenance: Disabled
AINS Soak: None
Total Duration: 0 hour(s) 0 minute(s)
Remaining Duration: 0 hour(s) 0 minute(s) 0 second(s)
Laser Squelch: Disabled
Phy:
Media type: Not known
Autonegotiation disabled.
Operational values:
Speed: 100Gbps
Duplex: Full Duplex
Flowcontrol: None
Loopback: None (or external)
BER monitoring:
Not supported
Holdoff Time: 0ms
Viewing Neighbor MAC Address
You can view the neighbor's physical address after enabling MAC address or ARP snoop using the following
command. MAC address snoop output is enabled after ARP packets are received on the respective 100G
client.
show controllers hundredGigEctrlr R/S/I/P
The following sample shows the neighbor's MAC address after configuring MAC address or ARP snoop on
client ports.
RP/0/RP0/CPU0:ios#show controllers hundredGigECtrlr 0/1/0/2
Mon Mar 16 19:41:08.047 UTC
Operational data for interface HundredGigECtrlr0/1/0/2:
State:
Administrative state: enabled
Operational state: Up
LED state: Green On
Maintenance: Disabled
AINS Soak: None
Total Duration: 0 hour(s) 0 minute(s)
Remaining Duration: 0 hour(s) 0 minute(s) 0 second(s)
Laser Squelch: Disabled
Neighbor Address:
0010.9400.5502
Configuring Controllers
29
Configuring Controllers
Viewing Neighbor MAC Address

Cisco NCS1004 Specifications

General

Brand	Cisco
Model	NCS1004
Category	Network Hardware
Language	English