2-5
Cisco UCS C220 M4 Server Installation and Service Guide
OL-32473-01
Chapter 2 Installing the Server
Installing the Server In a Rack
Installing the Server In a Rack
This section contains the following sections:
• Installing the Slide Rails, page 2-5
• Installing the Cable Management Arm (Optional), page 2-8
• Reversing the Cable Management Arm (Optional), page 2-9
Installing the Slide Rails
This section describes how to install the server in a rack using the rack kits that are sold by Cisco.
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to ensure
your safety:
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component
at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack.
Statement 1006
Step 1 Attach the inner rails to the sides of the server:
a. Align an inner rail with one side of the server so that the three keyed slots in the rail align with the
three pegs on the side of the server (see Figure 2-1).
b. Set the keyed slots over the pegs, and then slide the rail toward the front to lock it in place on the
pegs. The front slot has a metal clip that locks over the front peg.
c. Install the second inner rail to the opposite side of the server.
Figure 2-1 Attaching Inner Rail to Side of Server
1 Front of server 2 Locking clip on inner rail
To Next Page
Loading...
Need help?
General
Weight and Dimensions
