2-10
Catalyst 2940 Switch Hardware Installation Guide
OL-6157-01
Chapter 2 Installation
Installing the Switch
Figure 2-5 Installing the Mounting Screws on a Wall
Step 3
Peel the adhesive strip off the bottom of the screw template.
Step 4 Attach the screw template to the wall.
Step 5 Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2 inch (12.7 mm) hole in the three screw
template slots.
Step 6 Insert three screws in the slots on the screw template, and tighten until they touch the top of the
screw template.
Step 7 Remove the screw template from the wall.
1 Wall
2 Screws
3 Screw template
CABLE SIDE ENTRY
THIS SIDE AWAY FROM
MOUNTING SURFACE
SCREW
TEM
PLATE
P/N 700-17464-01 REV. A0
89854
2
3
2
2
1
To Next Page
Loading...
Need help?
General