Cisco XR 12000 Series Installation Guide

23
Cisco XR 12000 Series Router Ethernet Line Card Installation
OL-7861-01
Removing and Installing GBICs
Step 6 Use a Phillips screwdriver to insert and tighten the two screws on the faceplate of the line card,
3 to 5 in-lbs, as shown in Figure 15.
Caution Apply no more than 5 in-lbs of torque when tightening the screw.
Figure 15 Inserting the 2 screws on the Faceplate of the Line Card
Removing and Installing GBICs
Your Ethernet line card may have shipped with a GBIC installed. If your line card arrived without the
GBIC installed and you need to install it now, or if you need to change your GBIC for another reason,
use the procedures in these sections:
• General GBIC Handling and Maintenance Guidelines, page 24
• Removing the GBIC from an Ethernet Line Card, page 24
• Inserting a GBIC into the Gigabit Ethernet Interface, page 25
Before you remove or install a GBIC, read the installation information in this section and the “Laser
Safety” section on page 82.
Note Cisco strongly recommends that you disconnect all fiber-optic cables before removing or installing a
GBIC.
129856
PUSH
C
ORNERS
TO
INSTALL
PUSH
C
ORN
ERS
TO
INST
ALL

Cisco XR 12000 Series Specifications

General

Brand	Cisco
Model	XR 12000 Series
Category	Network Router
Language	English