Clarion M303 User Manual

Basic Operations
Note:
•
Refer to the diagrams
in
"3.
CONTROLS"
when reading this chapter.
A
CAUTION
When the unit is turned on, starting and
stopping the engine with its
volume
raised to
the maximum level
may harm your hearing.
Be
careful
about adjusting the
volume.
Power on I
off
Notes:
• Start the engine before using this unit.
•
Be careful about using this unit for a
long
time without running the engine.
If
you
drain the battery too far, you may not be
able
to start the engine and this can reduce
the service
life
of the battery.
1.
Start the engine. The power button
I
knob
illumination
on
the unit
will light
up.
~
EngineON
\...!::?WJ
position
2.
Press the
[SRC
I
c.9
]
button
on
the front
panel
or the remote control
to
turn
on
the
power under standby mode. The unit goes
back
to
the last
status after power
on.
3.
Press and
hold
the
[SRC
I
c.9]
button
on
the
front
panel
or the remote control
to
turn off
the power.
Mute
Press the
[MUTE]
button
on
the remote
control
to mute the volume from
the unit.
Note
:
Doing the operation above again or adjusting
volume
will
release muting.
Volume adjustment
Rotate the
[VOLUME]
knob
on
the front
panel
or press
the [
..a.
]
or [
.,..
] button
on
the remote
control.
The adjustable range of volume is
0
to
40.
A
CAUTION
While
driving, keep the
volume level
at
which external
sounds can
still
be heard.
Playing source selection
Press
[SRC
I
c.9
]
button
on
the front
panel
or
remote control
repeatedly
to choose desired
playing source.
Note:
Playing source selection means selecting which
mode, such as
DISC
mode,
RADIO
mode and
AUX
mode.
Display system time
Press the
[DISP]
button
on
the front
panel
or
remote
control to switch the display information
from
clock,
station information (radio mode), or
track information
(CD
mode).
RESET
If
you have following
problems, please press
[RESET]
button.
•
Unit can not power
on
•
Nothing happens when buttons are pressed
•
Display is not accurate
Note:
*
When the
[RESET]
button
is
pressed, preset
radio stations, audio setting, etc.stored
in
memory are retained.
~
0
~
1:1
=(f)
~
0
~
[]
RESET
System
Setup
In
any mode, press and
hold
[DISP]
button to
enter system setup. Press [ ...,...
] or [
..,_..
]
button to
select
options, rotate the
[VOLUME]
knob to adjust.
CLOCK
Press the
[VOLUME]
knob to
enter
clock
setting mode, rotate the
[VOLUME]
knob to
set clock, press [ ...,...
] or [
..,_..
] button to
select
hour or minute, press and
hold
the
[VOLUME]
knob to confirm.
DX/LO (RADIO
mode)
Rotate the
[VOLUME]
knob to choose radio
local
or distant at
RADIO
mode.
•
LO:
Only
stations with strong signal can
be received.
•
OX:
Stations with strong and weak signals
can be received.
AUX
SENS
(AUX mode)
Rotate the
[VOLUME]
knob to choose AUX
Input
sensitivity LOW,
MID
or HIGH
at
AUX
mode.
PARENTAL
PASSWORD
(SiriusXM mode)
Chanae parental password.
Original
code
is
"OOOO'ff
LOCK CH (SiriusXM mode)
Lock the current channel
UNLOCK
CH (SiriusXM mode)
Unlock current locked
channel.
UNLOCK
ALL CH (SiriusXM mode)
Unlock
all
parental
locked
channels.
ALERT:
ON/OFF
(SiriusXM mode)
Activate interruption by Artist and
Song alert
DELETE ALL ALERT (SiriusXM mode)
Delete saved alert
items for artist and song.
SELECT
(BT mode)
This
"SELECT"
menu
is
intended
to
automatically
paired by selecting a mobile
phone was stored.
This unit can store three
mobile
phones. The
mobile
phone will
be stored
in
paired order
to the unit. The fourth mobile phone can not
be stored.
If
you want to store a fourth
mobile
phone, please delete unwanted mobile phone
from
"DELETE"
menu.
1.
Rotate the
[VOLUME]
knob to
choose
the paired mobile phone name from the
pairing
list.
2.
Press and
hold the
[VOLUME]
knob to
confirm.
DELETE (BT mode)
1.
Rotate the
[VOLUME]
knob to choose
the paired mobile phone name from the
pairing
list.
2.
Press and
hold
the
[VOLUME]
knob to
confirm.
DISCONNECT
(BT mode)
Disconnect
currently
connected
mobile
phone.
1.
Rotate
the
[VOLUME]
knob,
mobile
phone displays are currently connected.
2.
Press and
hold
the
[VOLUME]
knob to
disconnect.
MIC GAIN
(BT mode)
Rotate the
[VOLUME]
knob to choose Mic
gain: -5,-4,-3,-2,-1
,0,
1,
2,
3,
4,
5.
You can change the gain of
MIG
when a
telephone partner cannot hear your voice.
MIC SEL
(BT mode)
Rotate
the
[VOLUME]
knob
to
choose
Microphone EXTERNAL or
INTERNAL.
TONE SEL
(BT mode)
You can get
mobile
phone ring tone from the
speaker.
Rotate
the
[VOLUME]
knob
to
choose
AUTO or INTERNAL.
•
AUTO:
Mobile phone ring tone from
the speaker.
INTERNAL:
The
unit
original
ring
tone
from
the
speaker.
AUTO ANS
(BT mode)
To answer incoming
calls automatically.
Rotate
the
[VOLUME]
knob
to
choose
AUTO ANS
ON
or
OFF.
AUTO CON: ON/OFF
(BT mode)
Automatically
connects the mobile phone
was
last
connected.
Rotate
the
[VOLUME]
knob
to
choose
AUTO
CON
ON
or
OFF.
PIN CODE
Rotate
and
press
the
[VOLUME]
knob
to
choose
a 4-digit password. Press the
[VOLUME]
knob more than 1 seconds to
confirm.
The
PIN
CODE default
setting
is"
0000 ".
M303
9

Clarion M303 Specifications

General

Brand	Clarion
Model	M303
Category	Marine Equipment
Language	English