InteliLite
NT
– MRS10/11/15/16, SW version 1.5, ©ComAp – September 2009 4
IL-NT-MRS-1.5-Reference Guide.pdf
General Guidelines
What describes this manual?
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTION - This manual contains important instructions for IL-NT
controllers family that shall be followed during installation and maintenance of the Inteli NT genset
controllers.
It is intended for use by gen-set control panel builders and for everybody who is concerned with
installation, operation and maintenance of the gen-set.
This manual describes „MRS 10/11/15/16“ software, which is designed for single set applications.
What is the purpose of the manual?
This manual provides general information how to install and operate InteliLite-NT MRS controller.
This manual is dedicated for
Operators of gen-sets
Gen-set control panel builders
For everybody who is concerned with installation, operation and maintenance of the gen-set
!! Warnings !!
Remote control
InteliLite
NT
controller can be remotely controlled. In case of the work on the gen-set check, that
nobody can remotely start the engine.
To be sure:
Disconnect remote control via RS232 line
Disconnect input REM START/STOP
or
Disconnect output STARTER and outputs GCB CLOSE/OPEN
Because of large variety of InteliLite
NT
parameters settings, it is not possible to describe any
combination. Some of InteliLite
NT
functions are subject of changes depend on SW version.
The data in this manual only describes the product and are not warranty of performance or
characteristic.
InteliLite controller SW and HW versions compatibility
Be aware that IL-NT SW version 1.2.1 and older is not possible to use with IL-NT HW version 1.3 and
newer!!! Software IL-NT 1.3 is compatible with IL-NT hardware version 1.3 and older.
Symbols
Symbols used in this manual:
Grounding
point symbol
AC voltage
symbol
DC voltage
symbol
To Next Page
Loading...
Need help?
General
