InteliLite
NT
– MRS10/11/15/16, SW version 1.5, ©ComAp – September 2009 6
IL-NT-MRS-1.5-Reference Guide.pdf
General Description
Description of the controller system (with all options)
InteliLite
NT
-MRS is a comprehensive controller for single generating sets. IL-NT MRS 15/16 features
extended support of electronic engines and extension modules.
InteliLite
NT
controllers are equipped with a powerful graphic display showing icons, symbols and bar-
graphs for intuitive operation, which sets, together with high functionality, new standards in Gen-set
controls.
InteliLite automatically starts the Gen-set, closes the Gen-set C.B. when all conditions are met, then
stops the engine on external signal or by pressing push buttons.
InteliLite
NT
provides gas engine support without ventilation.
The key feature of InteliLite
NT
is its easy-to-use operation and installation. Predefined configurations
for typical applications are available as well as user-defined configurations for special applications.
What is in the package?
Accessories Description Optional / Obligatory
IL-NT MRS InteliLite
NT
central unit Obligatory
IL-NT RS232 RS232 communication card Optional for MRS
IL-NT-RS232-485 RS232 and RS485 communication card Optional for MRS
IL-NT-S-USB Service USB communication card Optional for MRS
IB-Lite Ethernet communication card Optional for MRS
IL-NT AOUT8 Gauge driver card Optional for MRS
IL-NT-BIO8 Configurable I/O plug-in card Optional for MRS
*IL-NT RD Remoted display software Optional for MRS
IGL-RA15 Remote annunciator Optional for MRS15/16
IG-IOM/PTM I/O extension module Optional for MRS15/16
IG-IB Internet communication bridge Optional for MRS
AT -LINK-CONV Service programming RS232 interface Optional for MRS
AT-LINK-CABLE Serial RS232 communication cable 1,8m Optional for MRS
*Remote display for IL-NT controllers uses standard IL-NT controller with Remote
display software
Hint:
For detailed information about extension modules used with IL-NT controllers, please see the IL-NT-
Accessory Modules manual.
IL-NT RS232 Communication plug-in card
IL-NT RS232 is optional plug-in card to enable InteliLite
NT
for RS232 communication. This is required
for computer or Modbus connectin. Card inserts into expansion slot back on the controller.
To insert the module, you must open the cover first (use screwdriver to open) and then insert the
module into slot. Once you have insert it, the module will snap under plastic teeth. It is supposed to be
installed permanently. Should you need to remove it, the safest way is to remove whole back cover
and than remove module manually.
To Next Page
Loading...
Need help?
General
