ComAp InteliSys NT User Manual

InteliGen
NT
, InteliSys
NT
, InteliMains
NT
– Troubleshooting Guide,
SW version IGS-NT-3.1.0, IM-NT-3.1.0, ©ComAp – August 2018 24
IGS-NT Troubleshooting Guide.pdf
List of Abbreviations
AMF
Auto Mains Failure (controller starts automatically on mains failure)
AI
Analog Input
AO
Analog Output
ATS
Automatic Transfer Switch (switches load to supplied bus (by mains or generators))
AVR
Automatic Voltage Regulator
BI
Binary Input
BO
Binary Output
BOC
Breaker Open & Cool-down - protection type (see application manual for details)
BTB
Bus-Tie Breaker
CAN1
CAN bus for ComAp extension modules (e.g. IGS-PTM) and engine ECU
connection
CAN2
CAN bus for communication between ComAp controllers and communication
modules connection (e.g. I-LB+)
COX
Application for Complex Systems where actions are taken by a PLC and controller
only follows orders => needs an external driver (cox)
CT
Current Transformer
ECU
engine Electronic Control Unit
ESF
Engine Specific File
Forward synchronisation
Synchronisation of unloaded genset to mains (GCB closing process)
FMI
Failure Mode Identifier
GC
Graphical Characters - option for additional support of one "graphical" language
GCB
Generator Circuit Breaker
CHP
Combined Heat & Power - cogeneration application, usually with gas engine
I-AOUT8
Extension module with 8 AO
I-CB
Communication Bridge - interfaces IS, IG/IS-NT, ID controllers and non-standard
engine ECU
IG-AVRi
IG Automatic Voltage Regulator interface
IG-EE
InteliGen for Electronic Engines (HW optimized for connection to an engine
equipped with ECU)
IG-EEC
InteliGen EE controller with extended communication possibilities + switchable
sensing ranges of AC voltages and currents
IG-IB
IG-Internet Bridge - for internet/ethernet communication
IGL-RA15
Indication panel with LEDs signalizing state of 15 BO
IG-NT
InteliGen New Technology gen-set controller
IG-NTC
InteliGen NT controller with extended communication possibilities + switchable
sensing ranges of AC voltages and currents
IGS-NT-LSM+PMS
Dongle for IG-XX and IS-NT to enable Load Sharing and VAr sharing control loops
and PMS
IGS-PTM
Extension module with 8 BI/BO, 4 AI and 1 AO
I-LB
Local Bridge – for direct and modem monitoring and control of multiple gen-sets
IM-NT
InteliMains New Technology - Mains supervision controller; the same controller with
a different SW configuration can work as a bus-tie synchronizer
I-RB
Relay Board
IS-AIN8
Extension module with 8 AI.
IS-BIN8/16
Extension module with 8 BO and 16 BI.

ComAp InteliSys NT Specifications

General

Brand	ComAp
Model	InteliSys NT
Category	Controller
Language	English