USER GUIDE
11
Location Requirements
The standard KNIGHT
2
KL408 models can be mounted on any location that is 47" x 25", additionally
allow for a minimum of 3" of space around the perimeter of the nested tower. The surface should be
at or have only a slight crown. For a recessed installation, allow for a minimum of 3" of space around
the perimeter of the tower taking into consideration the dimensions of the tower both fully nested and
fully elevated. Consult with factory before construction of recessed installation. Verify all dimensions
before installation to ensure proper operation of light will not infringe on other installed components.
For all other installations refer to the dimensional drawing on page 22 of this guide that represents
your particular model of light. The drawings reect the dimensions of the “working envelope” of a
typical light tower. Make certain sufcient clearances are incorporated in your installation to allow
for variations (vehicle body ex, environmental conditions, future servicing needs, etc.) If your light
model is not represented, call or email the factory prior to beginning any construction of a recessed
installation.
Four mounting bolt holes are required. Additional holes may be drilled in the frame ends if necessary to
clear obstructions.
Access holes for the power cord cabling should be in close proximity to the relay box access holes on
the light. Installing the cords with a sweeping 90º or 180º bend will provide better results.
The control box holster should be mounted in an area shielded from the weather. Allow a minimum of
10” clearance above the control box holster mounting location for easy access to the controller.
To Next Page
Loading...
Need help?
General
