USER GUIDE
13
Electrical Wiring
Please Note: Detailed internal wiring schematics are located at the back of this user guide.
Run the control wire from the control box holster to the KNIGHT
2
.
Run the power wire from the breaker box or generator to the KNIGHT
2
. An 80 Amp breaker is
recommended on DC models.
Make the control connections in the KNIGHT
2
relay box.
The Model KL408D series KNIGHT
2
comes pre-wired to connect to 12 VDC.
12 VDC
Holster Wiring
Determine if an elevated warning device will be used in conjunction with the light tower. If a warning
device will be used, use the wiring diagram on the next page, otherwise, use the wiring diagram in the
back of the user guide.
After routing the control cable into the holster through the sealing connector, attach individual wires to
the provided connectors and insert the connectors into the proper ports on the circuit board
To Next Page
Loading...
Need help?
General
