Craftsman 7-1/4 - in. Circular Saw with Laser Trac and LED Worklight User Manual

Non-Through Cuts
Any cutting operation where the blade does not extend completely through the
thickness of the workpiece, like a dado cut.
Leading End
The end of the workpiece pushed into tool firsL
Kerr
The material removed by the blade in a through cut or the slot produced by the blade
in a non-through or partial cut
Kickback
A hazard that can occur when the blade binds or stalls, throwing the workpiece back
toward operator.
Workpiece or Material
The item on which the cutting operation is being done_ The surfaces of a workpiece
are commonly referred to as faces, ends and edges.
Gum
A sticky, sap-based residue from wood products.
Resin
A sticky, sap-based substance that has hardened.
/_ WARNING: Your saw should NEVER be connected to the power source
when you are assembling parts, making adjustments, installing or removing
blades, cleaning or when It is not In use. Disconnecting the saw will prevent
accidental starting, which could cause serious personal Injury.
1. The saw's cutting blade is installed at the factory.
2. The edge guide is force-fitted into the top of the lid of the storage/carrying case.
3. The blade wrench is also force-fitted into the top of the lid of the case. The wrench
is used when changing or installing a new blade.
4. Also included and attached to the top of the lid of the case with a hook and loop strap
is a pair of Laser enhancing safety glasses which are used to enhance the laser
beam in bright light conditions.
5o There Is a blade storage area in the bottom of the case where an extra blade can
be stored.
6. Inspect the saw carefully to make sure that no breakage or damage has occurred
during shipping, tf any of the items mentioned are missing (refer to PARTS LIST
on page 13), return the saw to your nearest Sears store or Craftsman outlet
to have the saw replaced.
_ WARNING: If any parts are broken or mlsslng, DO NOT attempt to plug
in the power cord or operate saw until the broken or missing parts are replaced.
Failure to do so could result In posslble serious Injury.
12

Craftsman 7-1/4 - in. Circular Saw with Laser Trac and LED Worklight Specifications

General

Brand	Craftsman
Model	7-1/4 - in. Circular Saw with Laser Trac and LED Worklight
Category	Saw
Language	English