PARTS LIST
FIg. 1
1. Saw
2. Blade
(Installed at factory)
3. Edge Guide I_1
(stored in case) -_
j
4. Blade Wrench
(stored in case)
5, Laser enhancing_
safety glasses C/\_
(for enhancing laser)
6. Operator's Manual
KNOW YOUR CIRCULAR SAW (Fig. 2)
I NOTE: Before attempting to use your saw, familiarize yourself with all of the
operating features and safety requirements. I
Your circular saw has a precision-built electric motor and itshould only be connected to a
120-volt, 60-Hz AC ONLY power supply (normal household current). DO NOT operate on
direct current (DC). This large voltage drop will cause a loss of power and the motor wtll
overheat° If the saw does not operate when plugged into correct 120-volt, 60-Hz AC ONLY
outlet, check the power supply The saw has an 8-ft, 2-wire power cord (no adapter needed).
This Circular Saw has the following features:
1.14 Amp, 5000 RPM (no-load speed) motor provides the power and torque for fast,
sure cuts in wood, plywood, hardboard and wood-base materials.
2, Laser TracTMThe unique, Innovative feature for accurate, efficient cuttlngl
3_LED WORKLIGHT illuminates cutting area for easy visibility.
This light stays "On" when saw is plugged into power source.
4 Quick depth-of-cut adjustments with a maximum depth of cut:
2 3/s-In. thick at 90°; 1 13h6-1n. thick at 45°
5. Easy to read bevel cut scale adjusts from 0° to 54,5 ° bevel capacity.
6. Die-cast aluminum blade guards for extra strength and durability.
7_Extended length trigger switch\ for maximum control and comfort.
Squeeze for power "ON", release for power "OFF".
8. Oversized machined aluminum base has integrated rip and crosscut ruler.
9. Soft-grip ergonomtcally designed contoured rear handle and front assist handle
for positive gripping, control, balance and comfort.
10_includes Craftsman ®24 tooth carbide-tipped steel general purpose blade.
I
I
_J
13
To Next Page
Loading...
Need help?
General