ELECTRICALSAFETY
I /_ WARNIN G: Do not permit fingers to touch the terminals of plug when
installing or removing the plug from the outlet.
1. Double insulated tools are equipped with a polarized plug (one blade is wider than
the other). This plug will fit in a polarized outlet only one way, If the plug does not
fit fully In the outlet, reverse the plug. If itstill does not fit, contact a qualified electrician
to install a polarized outlet. Do not change the plug in any way.
2. Double Insulation [] eliminates the need for the
three-wire grounded power cord and grounded
power supply system. Applicable only to Class It
(double-insulated) tools. This circular saw is
a double Insulated tool.
Cover of
Grounded ®
Outlet Box ----" (_
/_ WARNING: Double insulation DOES NOT take the place of normal safety
precautions when operating this tool,
3. BEFORE plugging in the tool, BE SURE that the outlet voltage supplied is within
the voltage marked on the tool's data plate. DO NOT use "AC only" rated tools with
a DC power supply,
4,, AVOID body contact with grounded surfaces, such as pipes, radiators, ranges
and refrigerators, There isan increased risk of electric shock if your body is
grounded.
5. DO NOT expose power tools to rain or wet conditions or use power tools in
wet or damp locations. Water entering a power tool will increase the risk of
electric shock.
6. INSPECT tool cords for damage. Have damaged toot cords repaired at a Sears
Service Center. BE SURE to stay constantly aware of the cord locationand keep
itwell away from the moving blade.
7. DO NOT abuse the cord. NEVER use the cord to carry the toot by or pull the
plug from the outlet. Keep cord away from heat, oil, sharp edges or moving parts,
Replace damaged cords immediately. Damaged cords increase the risk of electric
shock.
To Next Page
Loading...
Need help?
General