STARTING A CUT (Fig. 9)
I _ WARNING: ALWAYS clamp and support workpiece securely. ALWAYS
maintain proper control of saw° Failure to clamp and support workpiece and loss of
control of saw could result in serious injury,
1. ALWAYS use your saw with your hands positioned correctly, with one hand operating
the trigger switch and the other on the front assist handle (see Fig. 9).
z_"WARNING: ALWAYS maintain proper control of the saw to make sawing safer
and easier. Loss of control of the saw could cause an accident resulting in possible
serious injury°
2° NEVER use the saw with your Fig. 9
hands positioned as shown in Fig. 10
To Help Maintain Control"
3. ALWAYS support the workpiece
near the cut,
4. ALWAYS support the workpiece
so the cut will be on your right°
5, ALWAYS clamp the workpiece
so itwill not move during the cut,
Place the workpiece with the
good side down.
i NOTE: Thegood sldeof workpieoe appearance important.
the is the side where is
6. Before starting a cut, draw a guideline along
the desired line of cut, then place the front
edge of the saw base on that part of the
workptece that is solidly supported (see Fig. 9)°
7. NEVER place the saw on the part of the
workpiece that will fall off when the cut
is made (see Fig. I0).
8. ALWAYS keep the cord away from the
cutting area. ALWAYS place the cord so it
does not hang up on the workpiece when
making a cut.
Hold the saw firmly with both hands (see Fig 9).
g_
I
I
Fig, 10
i i
Z_ WARNING: If the cord hangs up on the workpieee during a cut, release the
trigger switch immediately, To avoid injury, unplug the saw and move the cord to
prevent it from hanging up again.
Using the saw with a damaged cord could result in serious injury
or death. If the cord has been damaged, have it replaced before using the saw again.
20
To Next Page
Loading...
Need help?
General