Crestron DM-TX-201-C Supplemental Guide

Supplemental Guide — Doc. 6958E DM-TX-201-C • 7
TCP/IP Communications via the LAN Port of the DM-TX-201-C
To establish TCP/IP communications via the LAN port of the DM-TX-201-C, do the
following:
1. Using the Device Discovery Tool, find the IP address of the DM-TX-201-C.
NOTE: In a stand-alone configuration, DHCP is enabled by default. If desired, the
default IP address can be assigned by holding down the SETUP button while
applying power. The default IP address, which is 192.168.1.236, overwrites the
current setting and remains until it is changed.
2. Using the Address Book, create an entry for the DM-TX-201-C using the TCP
connection type, and then enter the IP address.
3.
In the Crestron Toolbox toolbar, click . The System Info window opens.
4. In the drop-down list at the bottom of the System Info window, select the entry of
the DM-TX-201-C. Device information is displayed.
5. (Optional) If additional changes to TCP/IP settings are desired, do the following:
a. In the Functions menu, select Ethernet Addressing.
b. Enter the static IP address, IP mask, and default router for the DM-TX-201-C.
c. Close the System Info window.
d. Change the Address Book entry for the DM-TX-201-C so that it uses the IP
address assigned in step 4b.
e.
In the Crestron Toolbox toolbar, click . The System Info window opens.
f. In the drop-down list at the bottom of the System Info window, select the
entry of the DM-TX-201-C. Device information is displayed.
IP Table Configuration
Configuration of the IP table of the DM-TX-201-C is necessary only when the
DM-TX-201-C connects to a control system and is used in a stand-alone configuration in
which it does not connect to a DM switcher.
NOTE: If the DM-TX-201-C connects to a DM switcher, the IP table of the
DM-TX-201-C is created automatically.
To create the IP table of the DM-TX-201-C in a stand-alone configuration, use Crestron
Toolbox software and do the following:

Crestron DM-TX-201-C Specifications

General

Type	Network transmitter
Duplex system	Full, Half
Auto-negotiation	Yes
Ethernet LAN data rates	10, 100 Mbit/s
Maximum transfer distance	- m
Cabling technology	10/100Base-T(X)
Networking standards	IEEE 802.3at
RJ-45 ports quantity (transmitter)	2
Product color	Black
Output current	0.75 A
Output voltage	24 V
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	32 mm
Width	187 mm
Height	165 mm
Weight	721 g