Only Delay therapeutic program has this parameter setting. Press [S]
button cycle to enter this menu, and then press the [▲] and [▼]
button to adjusting the setting.
6) Set Ramp Time
The ramp time controls the time of output current that increase from
0 to the
7) Set Contract Time
The contract Time controls the time of stimulation. The contraction
time can be adjusted. Press [S] button cycle to enter this menu, and
then press the [▲] and [▼] button to adjusting the setting. Both
channels’ stimulation is cycled on and off by the contraction and
relaxation settings. The range is adjustable from 1 to 60 seconds.
Caution:
Contract time does not include the ramp up and ramp down
time; ON time=Ramp up + Contract time + Ramp down.
8) Set Relaxation (OFF) time
4.8 Adjust Channel Intensity
Press the intensity control button ([▲] and [▼]) to control the
intensity output. Slowly press the intensity button control until you
reach the setting recommended by your physician or therapist.
Repeat for the other channel, if both channels are to be used.
Caution:
1) If the stimulation levels are uncomfortable or become
uncomfortable, reduce the stimulation intensity to a
comfortable level and contact your medical practitioner if
problems persist.
2) If the electrodes are not placed firmly on the skin or the
The Off Time controls the time of relaxation. The relaxation time can
be adjusted. Press [S] button cycle to enter this menu, and then
press the [▲] and [▼] button to adjusting the setting. Both channels'
stimulation is cycled on and off by the contraction and relaxation
settings. The range is adjustable from 0 to 60 seconds.
In Alternate program, the OFF Time should be equal or more than
the ON Time. (OFF TIME ≥ON TIME)
To Next Page
Loading...
Need help?
General