changes to your settings and to prevent accidental increases to the
intensity levels.You can press either one of the button to unlock
device is not connected to the electrodes, and the
stimulator’s output intensity surpasses 12mA, the amplitude
level will be reset to 0 mA automatically.
4.9. Safety Lock Feature
4.10. Stop the treatment
When you have activated the treatment timer, you can press the [M]
button or the [
] button to control or stop the treatment.
Caution:
Default state, if the button is locked, you can press only one
of the [ ] buttons to unlock, and then press the [M] button or
the [ ] button to control stop the treatment.
4.11. Turn OFF
PRESS [ ] button and HOLD for approximately 3 seconds to
turn
OFF the device.
Caution:
1) If there is no operation in the panel for 2 minutes in the
waiting state, the device will be turned off automatically.
2) In shutdown state, keep pressing the channel 2[ ]first, and
then press [ ]button at the same to restore factory
parameter settings
The Safety Lock Feature automatically activates after there is no
operation in the panel for 30 seconds by locking out the ability to
press the buttons.This is a safety feature to prevent accidental
the device.
To Next Page
Loading...
Need help?
General